CB2-PIPE
3U, CompactPCI 5-Port USB 2.0 Host Controller
The CB2-PIPE is a 5-port USB2.0 host controller. The 3U CompactPCI® board complies with the Universal Serial Bus Specification Revision 2.0 and Open Host Controller Interface (OHCI) Specification for full-/low-speed signalling and the Intel Enhanced Host Controller Interface (EHCI) Specification for high-speed data transfers. All downstream facing ports can handle high-speed (480Mbps), full-speed (12Mbps), and low-speed (1.5Mbps) transaction. All USB power lines are protected against over-current and short circuit conditions. Four of five USB ports are accessible from the front panel. The fifth USB connector is situated on-board for system internal usage (e.g. USB stick or USB cable attached device).
Any popular operating system provides suitable drivers for the CB2-PIPE. In addition, any recent BIOS allows to boot from an USB device via OHCI or high speed EHCI data transfer modes.
Downloads & Ressources
Documents
Specifications
- 3U Eurocard (100x160mm2)
- Front panel width 4HP
- Peripheral Card 32bit, 33MHz (133MBps), 3.3V or 5V interface
- Ready for usage within PXI® systems
- Root hub with 5 downstream facing ports, all ports over-current protected, data transfer rate up to 480Mbps, conforming to USB2.0, OHCI Rev. 1.0a, EHCI Rev. 1.0
- Proven PCI to USB 2.0 controller NEC (Renesas) uPD720101
- USB port 1-4 wired to front panel type A connectors
- USB port 1-4 optionally wired to J2 for rear I/O usage (front panel connectors USB1-4 removed), stuffing option – please take into consideration before ordering
- USB port 5 wired to the on-board type A connector
- +5V ±5% 0.1A max. (w/o current required by USB devices via VBUS)
- +3.3V +0.17V/-0.1V 0.4A max. (w/o on-board Flash disk drive option)
- Vio 3.3V/5V 0.1A max.
Simplified Block Diagram